Hi,
I bought a new fan with UV lights for the cabinet (Later, I will post a picture of it in the review section ) ,now I'm confused how Should I connect it .,since it has one 3 pin and one 4 pin (to connect it directly to SMPS ).I know that if I connect it via Mother Board ,then its fan speed will be automatically controlled ,but If I connect it via SMPS ,then it will run at full speed.The problem is when I connect it via MB ,then its UV lights starts to Blink Too much .
What shall do now ?
I'm asking you because few days back I connected my old cabinet fan which had the following specification 12V DC and 0.27A,which stopped working after sometime .
and this new Glacialtech(GT 12025MSDL) fan has the following specification 12v and 0.31A
Also ,One which came with the cabinet has the following specification
12volt and 0.16A
Thanks in advance .
I bought a new fan with UV lights for the cabinet (Later, I will post a picture of it in the review section ) ,now I'm confused how Should I connect it .,since it has one 3 pin and one 4 pin (to connect it directly to SMPS ).I know that if I connect it via Mother Board ,then its fan speed will be automatically controlled ,but If I connect it via SMPS ,then it will run at full speed.The problem is when I connect it via MB ,then its UV lights starts to Blink Too much .
What shall do now ?
I'm asking you because few days back I connected my old cabinet fan which had the following specification 12V DC and 0.27A,which stopped working after sometime .
and this new Glacialtech(GT 12025MSDL) fan has the following specification 12v and 0.31A
Also ,One which came with the cabinet has the following specification
12volt and 0.16A
Thanks in advance .
Last edited: